[. . . ] ??If the mount becomes detached and falls while driving, a traffic accident or injury may occur. ??If you operate the unit in a location subject to direct sunlight, such as on a dashboard, or in a hot or humid place, such as in a car, this unit may unexpectedly malfunction. For details, refer to the operating instructions supplied with the camera. [. . . ] If the suction cup becomes dirty or scratched, its adhesive strength will be reduced. ??Make sure that the surface of the dashboard where you intend to install the mount is clean. Dirty surfaces will make the adhesive strength of the suction cup weak, and may cause unstable installation of the mount. ??Depending on the surface, be aware that the suction cup mount may leave a mark. ??The suction cup may be damaged if it is forcefully removed, or the mount is forced in a horizontal direction while still attached to the dashboard, or on the mount is forced in a horizontal direction before completely removing the suction cup from the dashboard. ??If the temperature of the surface of the dashboard is low, for example, in winter or when used in a cold region, removal of the suction cup may be difficult. ?? Maintenance ???????? ??????? PUSH?????????LOCK/RELEASE?????? ????????/Do not turn the LOCK/RELEASE ??????????????Otherwise, dirt will be difficult to remove, or the surface of the suction cup may be damaged. Do not use any tissue or towel to wipe off the surface of the suction cup. Tip You can also use a soft, wet lint-free cloth to clean the surface of the suction cup. Notas sobre la ventosa Hinweise zur Montagefolie Entretien lever while holding down the PUSH button. ?????? ??????????? ??????????? * This product can be configured for different heights. - ?) Before Installation Mount the mount on an area of the dashboard which is smooth and horizontal. - ?) When detaching the mount from the dashboard, reverse the attaching procedure. [. . . ] Use of other than the supplied parts may damage this unit or cause parts to become loose. ??Do not install the unit in a place exposed to rain or water, or in a location subject to high humidity or dust. Installing the unit in the location described above may cause a malfunction or injury. [. . . ]